System Diagnosis
Ignition Proving Failure. Control retries three times before lockout #14. Check flame sense, ground continuity, gas supply, HSI, and flame carryover.
Bryant Furnaces
Error Code 34
Troubleshooting guide for the Bryant Furnaces system fault 34.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
Potential Causes & Solutions
- Check gas pressure and burner operation.
- Inspect ignitor for cracks or carbon buildup.
- Clean or replace flame sensor.
- Verify proper gas valve operation and check for proper combustion air.
- Control retries 3 times before lockout 14.
Verify Before Replacing Parts
- Confirm the exact Bryant model family and furnaces context before acting on a generic code description.
- Walk the entire heating sequence in order instead of jumping straight to the reported code.
- Verify each safety device and prove where the sequence stops under live operation.
- After the correction, run the system long enough to confirm the code does not return under normal load.
Field Signals to Confirm
What usually confirms it
A repeatable stop in the heating sequence at the same safety or prove step.
What can fool you
Weak grounding, marginal flame signal, or venting issues can produce inconsistent code behavior.
When to Escalate the Call
- Safety devices keep opening after the obvious mechanical causes are corrected.
- Combustion, venting, or gas input needs a higher-confidence review.
Still unsure about this fault?
ACLogics walks you through Bryant Furnaces diagnostics step-by-step — so you confirm the cause before swapping parts.
