System Diagnosis
Brown Out (230 V). Line voltage is less than 187 V for at least 4 seconds; compressor and fan operation are not allowed until voltage exceeds 190 V.
Carrier Air Conditioners
Error Code 46
Troubleshooting guide for the Carrier Air Conditioners system fault 46.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
Potential Causes & Solutions
- Measure supply voltage at outdoor disconnect under load.
- Check for undersized wiring or loose connections.
- Contact utility company if supply voltage is consistently below spec.
Verify Before Replacing Parts
- Confirm the exact Carrier model family and air conditioners context before acting on a generic code description.
- Verify current draw, overload status, and control signal before condemning the compressor or drive.
- Look for upstream conditions such as airflow or charge issues that may be pushing the compressor into protection.
- After the correction, run the system long enough to confirm the code does not return under normal load.
Field Signals to Confirm
What usually confirms it
Protection trips that line up with abnormal current draw, temperature, or drive behavior.
What can fool you
Upstream airflow or refrigerant issues can push the compressor into protection even when the compressor is healthy.
When to Escalate the Call
- The compressor or drive shows repeat protection events under normal load.
- You cannot separate compressor health from upstream system issues with confidence.
Still unsure about this fault?
ACLogics walks you through Carrier Air Conditioners diagnostics step-by-step — so you confirm the cause before swapping parts.
