System Diagnosis
Evaporator Coil Temperature Sensor T2 Open or Short. Evaporator coil temperature sensor T2 open circuit or short circuit.
Carrier Ductless Systems
Error Code E5
Troubleshooting guide for the Carrier Ductless Systems system fault E5.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
Potential Causes & Solutions
- Check T2 sensor wiring and connector for damage or corrosion.
- Verify sensor is properly seated on evaporator coil.
- Measure sensor resistance and compare to chart.
- Replace T2 sensor if out of spec.
Verify Before Replacing Parts
- Confirm the exact Carrier model family and ductless systems context before acting on a generic code description.
- Confirm filter condition, blower operation, and coil cleanliness before replacing any controls.
- Measure airflow-related readings that match the symptom, such as temperature split or static pressure.
- After the correction, run the system long enough to confirm the code does not return under normal load.
Field Signals to Confirm
What usually confirms it
Weak airflow, abnormal temperature split, or repeated protective trips tied to blower performance.
What can fool you
Charge and control faults often look similar until airflow and coil condition are verified first.
When to Escalate the Call
- The code returns after airflow and cleanliness checks are corrected.
- You find evidence of duct or static issues that require a larger system review.
Still unsure about this fault?
ACLogics walks you through Carrier Ductless Systems diagnostics step-by-step — so you confirm the cause before swapping parts.
