System Diagnosis
Malfunction of heat exchanger thermistor
Daikin Split/ Multi Split
Error Code J6
Troubleshooting guide for the Daikin Split/ Multi Split system fault J6.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
Potential Causes & Solutions
- Defective connection of thermistor.
- Defective heat exchanger thermistor.
- Defective outdoor unit PCB.
Verify Before Replacing Parts
- Confirm the exact Daikin model family and split/ multi split context before acting on a generic code description.
- Verify the sensor or thermistor reading against the expected range for the current operating condition.
- Check the sensor harness and board connection before condemning the sensor itself.
- After the correction, run the system long enough to confirm the code does not return under normal load.
Field Signals to Confirm
What usually confirms it
Sensor values that do not match the operating condition or drift when the harness is moved.
What can fool you
A control board issue can look like a failed sensor if the reference voltage or connector is unstable.
When to Escalate the Call
- Sensor values remain unstable after connector and board checks.
- The model uses a proprietary sensor curve you cannot verify confidently in the field.
Still unsure about this fault?
ACLogics walks you through Daikin Split/ Multi Split diagnostics step-by-step — so you confirm the cause before swapping parts.
