System Diagnosis
Flame sensed with gas valve off (unexpected flame). This could indicate a gas valve leaking or stuck open, or a control board issue.
Trane | Furnaces
Error Code 5 Flashes
Troubleshooting guide for the Trane Furnaces system fault 5 Flashes.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
Potential Causes & Solutions
- Turn off the furnace.
- Do not continue operation until inspected.
- Check that the gas valve closes fully.
- This fault requires a qualified HVAC technician to examine the gas valve and control board.
Verify Before Replacing Parts
- Confirm the exact Trane model family and furnaces context before acting on a generic code description.
- Walk the entire heating sequence in order instead of jumping straight to the reported code.
- Verify each safety device and prove where the sequence stops under live operation.
- After the correction, run the system long enough to confirm the code does not return under normal load.
Field Signals to Confirm
What usually confirms it
A repeatable stop in the heating sequence at the same safety or prove step.
What can fool you
Weak grounding, marginal flame signal, or venting issues can produce inconsistent code behavior.
When to Escalate the Call
- Safety devices keep opening after the obvious mechanical causes are corrected.
- Combustion, venting, or gas input needs a higher-confidence review.
Diagnose with Confidence
Use the ACLogics AI assistant to walk through this error code step-by-step.
Included in Diagnosis Workflow
Ask
Upload nameplate & symptoms
Diagnose
AI isolates the likely furnaces branch behind code 5 Flashes
Report
Document the verified result and next action