System Diagnosis
Abnormal Flame-Proving Signal. Flame is proved while gas valve is de-energized.
Carrier Furnaces
Error Code 22
Troubleshooting guide for the Carrier Furnaces system fault 22.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
Potential Causes & Solutions
- Inspect flame sensor for leakage to ground.
- Check for shorted flame sensor wire.
- Verify gas valve closes completely when de-energized.
- Replace flame sensor or gas valve if defective.
Verify Before Replacing Parts
- Confirm the exact Carrier model family and furnaces context before acting on a generic code description.
- Walk the entire heating sequence in order instead of jumping straight to the reported code.
- Verify each safety device and prove where the sequence stops under live operation.
- After the correction, run the system long enough to confirm the code does not return under normal load.
Field Signals to Confirm
What usually confirms it
A repeatable stop in the heating sequence at the same safety or prove step.
What can fool you
Weak grounding, marginal flame signal, or venting issues can produce inconsistent code behavior.
When to Escalate the Call
- Safety devices keep opening after the obvious mechanical causes are corrected.
- Combustion, venting, or gas input needs a higher-confidence review.
Still unsure about this fault?
ACLogics walks you through Carrier Furnaces diagnostics step-by-step — so you confirm the cause before swapping parts.
