System Diagnosis
Hard lockout active.
Trane | AC and Heat Pump
Error Code Green LED (Intermittent Flash – 1 flash every 4 sec)
Troubleshooting guide for the Trane AC and Heat Pump system fault Green LED (Intermittent Flash – 1 flash every 4 sec).
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
Potential Causes & Solutions
- The system is locked out due to a serious fault (e.g.
- high/low pressure).
- The red LED will flash the specific error code; power cycling is usually required to reset after resolving the issue.
Verify Before Replacing Parts
- Confirm the exact Trane model family and ac and heat pump context before acting on a generic code description.
- Verify airflow first, then confirm operating pressures and temperature relationship before adjusting charge.
- Look for restrictions, iced coils, or dirty heat-transfer surfaces that can mimic a charge problem.
- After the correction, run the system long enough to confirm the code does not return under normal load.
Field Signals to Confirm
What usually confirms it
Pressure and temperature readings that stay out of range after airflow is verified.
What can fool you
Dirty coils or airflow restrictions can look like a charge problem until the air side is cleaned up.
When to Escalate the Call
- You suspect a restriction, leak, or compressor issue that needs deeper system evaluation.
- The readings do not normalize after airflow and coil conditions are corrected.
Diagnose with Confidence
Use the ACLogics AI assistant to walk through this error code step-by-step.
Included in Diagnosis Workflow
Ask
Upload nameplate & symptoms
Diagnose
AI isolates the likely ac and heat pump branch behind code Green LED (Intermittent Flash – 1 flash every 4 sec)
Report
Document the verified result and next action