System Diagnosis
High Pressure Switch Open. High-pressure switch is open; board indicates the event and retries after 15 minutes.
Bryant Heat Pumps
Error Code 31
Troubleshooting guide for the Bryant Heat Pumps system fault 31.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
Potential Causes & Solutions
- Check refrigerant charge level.
- Inspect outdoor fan operation and coil for airflow restrictions or debris.
- In heating mode, check indoor coil for airflow restrictions.
- Verify refrigerant charge is within specification.
Verify Before Replacing Parts
- Confirm the exact Bryant model family and heat pumps context before acting on a generic code description.
- Verify airflow first, then confirm operating pressures and temperature relationship before adjusting charge.
- Look for restrictions, iced coils, or dirty heat-transfer surfaces that can mimic a charge problem.
- After the correction, run the system long enough to confirm the code does not return under normal load.
Field Signals to Confirm
What usually confirms it
Pressure and temperature readings that stay out of range after airflow is verified.
What can fool you
Dirty coils or airflow restrictions can look like a charge problem until the air side is cleaned up.
When to Escalate the Call
- You suspect a restriction, leak, or compressor issue that needs deeper system evaluation.
- The readings do not normalize after airflow and coil conditions are corrected.
Still unsure about this fault?
ACLogics walks you through Bryant Heat Pumps diagnostics step-by-step — so you confirm the cause before swapping parts.
