System Diagnosis
Compressor C1 Alert. Current sensor does not detect compressor C1 current during operation, or detects current when compressor C1 should be off.
Carrier Outdoor Packaged Units
Error Code 59
Troubleshooting guide for the Carrier Outdoor Packaged Units system fault 59.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
Potential Causes & Solutions
- Check compressor C1 wiring and contactor.
- Verify current sensor wiring and positioning.
- Test for compressor C1 open winding or open circuit.
- Inspect compressor contactor for welded contacts if current detected after turnoff.
Verify Before Replacing Parts
- Confirm the exact Carrier model family and outdoor packaged units context before acting on a generic code description.
- Verify the sensor or thermistor reading against the expected range for the current operating condition.
- Check the sensor harness and board connection before condemning the sensor itself.
- After the correction, run the system long enough to confirm the code does not return under normal load.
Field Signals to Confirm
What usually confirms it
Sensor values that do not match the operating condition or drift when the harness is moved.
What can fool you
A control board issue can look like a failed sensor if the reference voltage or connector is unstable.
When to Escalate the Call
- Sensor values remain unstable after connector and board checks.
- The model uses a proprietary sensor curve you cannot verify confidently in the field.
Still unsure about this fault?
ACLogics walks you through Carrier Outdoor Packaged Units diagnostics step-by-step — so you confirm the cause before swapping parts.
