System Diagnosis
Compressor Open Start Circuit. The ICC detects current in the Run circuit but not in the Start circuit of the compressor four (4) times in one compressor call.
Rheem | Default
Error Code L6
Troubleshooting guide for the Rheem Default system fault L6.
R
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
Potential Causes & Solutions
Verify Before Replacing Parts
- Confirm the exact Rheem model family and default context before acting on a generic code description.
- Verify current draw, overload status, and control signal before condemning the compressor or drive.
- Look for upstream conditions such as airflow or charge issues that may be pushing the compressor into protection.
- After the correction, run the system long enough to confirm the code does not return under normal load.
Field Signals to Confirm
What usually confirms it
Protection trips that line up with abnormal current draw, temperature, or drive behavior.
What can fool you
Upstream airflow or refrigerant issues can push the compressor into protection even when the compressor is healthy.
When to Escalate the Call
- The compressor or drive shows repeat protection events under normal load.
- You cannot separate compressor health from upstream system issues with confidence.
Diagnose with Confidence
Use the ACLogics AI assistant to walk through this error code step-by-step.
Included in Diagnosis Workflow
Ask
Upload nameplate & symptoms
Diagnose
AI isolates the likely default branch behind code L6
Report
Document the verified result and next action