Lennox Equipment not specified

Lennox Error Code 401

Equipment not specified:

What It Means

  • OD Compressor Long Run Cycle

Causes & actions from Lennox

How it shows
  • iComfort S30 alert: 401

Priority condition: Information Only-Dealer Either the compressor ran for more than 18 hours continuously while attempting to cool the home during a single demand or the system refrigerant pressure is low. • Alert code will not lockout system. • If the two-stage outdoor unit has an outdoor control with flashing LED lights then the unit will run in low speed; • An outdoor control with a seven-segment display, the outdoor control will display alert code 401, but continue to run in high speed. • If the outdoor unit is a heat pump, and the outdoor temperature is less than 65°F, alert code 401 is ignored. • Also monitors low pressure switch trips.

Applicable models & manual sources
Disclaimer: This information is for general reference. Code wording and instructions vary by model. Always follow the service manual for your exact unit.

What should you check next?

Continue in ACLogics with guided diagnosis for your equipment and symptoms.

See how guided diagnosis works →