Lennox XP15 Error Codes
Equipment type not specified · Split & Multi-Split
- 1 Long Run Time - Compressor is running extremely long run cycles.
- 2 System Pressure Trip - Discharge or vapor pressure out of limits or compressor overloaded
- 3 Short Cycling - Compressor is running only briefly
- 4 Locked Rotor
- 5 Open Circuit
- 6 Open Start Circuit - Current only in run circuit
- 7 Open Run Circuit - Current only in start circuit
- 8 Welded Contactor - Compressor always runs
- 9 Low Voltage - Control circuit <17VAC
- DS2 ALTERNATING FAST FLASH, DS1 ALTERNATING FAST FLASH Coil sensor problem
- DS2 ALTERNATING SLOW FLASH, DS1 ALTERNATING SLOW FLASH 5-minute anti-short cycle delay
- DS2 OFF, DS1 FAST FLASH Discharge sensor fault
- DS2 OFF, DS1 OFF Power problem
- DS2 OFF, DS1 ON Low Pressure Lockout
- DS2 OFF, DS1 SLOW FLASH Low pressure fault
- DS2 ON, DS1 OFF High Pressure Lockout
- DS2 ON, DS1 ON DCB failure
- DS2 SIMULTANEOUS FAST FLASH, DS1 SIMULTANEOUS FAST FLASH Ambient sensor problem
- DS2 SIMULTANEOUS SLOW FLASH, DS1 SIMULTANEOUS SLOW FLASH Normal operation
- DS2 SLOW FLASH, DS1 OFF High pressure fault
- Green Power LED OFF LSOM not powering up
- Green Power LED ON LSOM has power
- Red Trip LED ON System and compressor check out OK Thermostat demand signal Y1 is present, but compressor…
- Red Trip and Yellow Alert LEDs Flashing Simultaneous flashing.
Reference only. Confirm against the manual for your exact model. Data release 105f66ecb9e96e5dc473025d.