What It Means
- iComfort S30: Duplicate Comfort Sensor ID
- CS7500: replace UV lamp
Lennox Equipment not specified
Lennox Equipment not specified Error Code 13
Equipment not specified
13 means different things on different Equipment not specified models. Enter your model number to see only your reading, or find your model below.
Causes & actions from Lennox
Duplicate Comfort Sensor ID
Models: iComfort S30
How it shows
- iComfort S30 alert: 13
Priority condition: Service Urgent Thermostat found more than one outdoor unit, or more than one indoor unit, or more than one thermostat connected to the system. Thermostat will display the message “Too Many Devices of the Same Type”. • Check wiring and remove duplicate equipment. • Go to menu > settings > advanced settings > view dealer control center > equipment and press reset all equipment. This will allow the system to auto-detect any Lennox communicating components attached.
Applicable models & manual sources
- iComfort S30
Duplicate Comfort Sensor ID
replace UV lamp
Models: CS7500
How it shows
- cs7500 notification display: 13
Touch either done to clear the reminder or remind later button.
Applicable models & manual sources
- CS7500
replace UV lamp
Disclaimer: This information is for general reference. Code wording and instructions vary by model. Always follow the service manual for your exact unit.
What should you check next?
Continue in ACLogics with guided diagnosis for your equipment and symptoms.
